Maloney Real Estate
Story-and-a-half house with tan siding, a covered front porch and an attached garage on a snowy residential street with bare trees
← The Maloney Report

Buyer Guides

Buying a Yankton Home With Boiler Heat? Ask These First

By Michelle Maloney, Broker/Owner, Maloney Real Estate · SD License #14315

You can buy a boiler-heated home in Yankton, as long as you treat the heating system as its own inspection item. Start with the seller's disclosure statement, which has a line for the home heating system type and its age, if known. Have a heating contractor who services boilers look at it during your inspection window, and ask for the service records and the heating bills. Federal fire and safety guidance calls for a professional inspection of heating equipment every year and carbon monoxide alarms in every home, so build both into your first-winter plan.

Is a boiler-heated home a problem in Yankton?

No. It’s a different system from a furnace with ductwork, and you should shop it that way. When the house you love has radiators, baseboard units or heat in the floor, the questions change. You’ll want to know how old the boiler is, who has serviced it, what it costs to run and what replacing it would cost when the time comes.

Inside Yankton city limits, natural gas comes from MidAmerican Energy. That matters for a gas boiler, because its fuel use shows up on the MidAmerican bill. If the boiler runs on natural gas, ask the seller for the last 12 months of MidAmerican bills along with the electric bills, so you’re looking at the whole heating picture. For an oil, propane or electric boiler, or an address outside city limits, ask for the bills from whoever supplies that fuel.

South Dakota’s seller disclosure gives you the other starting point. The statutory form has a line for the home heating system type and the age of the system, if known, and a separate line for in-floor heat. Read those two lines before you fall for the woodwork.

What does the seller’s disclosure tell you about the boiler?

It tells you what the seller knows, and it tells you where to dig. On the South Dakota Seller’s Property Condition Disclosure Statement, the home heating system is item 20, with a blank for the type and another for the age of the system, if known. In-floor heat is item 23. The seller states that the information reflects their knowledge as of the date on the form.

The form also states its own limits. It isn’t a warranty, and it isn’t a substitute for any inspections either party may want. Treat it as a list of questions. An unknown answer means the age has to come from the records, the data plate or the person who services the boiler.

Use the heating lines this way:

  • If the age is filled in, compare it with the data plate on the boiler during your inspection.
  • If the age says unknown, ask whether the seller has service invoices, a prior inspection or the installer’s paperwork.
  • If in-floor heat is checked, ask which rooms have it and whether it runs off the same boiler as the radiators or baseboards.
  • If the seller reports a problem, get the details in writing and bring them to the person who looks at the boiler.

Questions to send the seller

Your agent can send these before or right after you’re under contract:

  • When was the boiler installed, and who installed it?
  • When was it last serviced, and by whom? Can you share the invoice?
  • Has it ever needed a major repair, a new pump or a replaced part?
  • Are there rooms that heat slower or never get as warm as the rest?
  • Was any part of the system shut off, drained or added onto?
  • What did the heating bills run last winter?

You’re looking for a pattern. A boiler with a named service company, dated invoices and steady bills is a different purchase from one nobody has touched in years. Our guide to South Dakota seller disclosure requirements explains how the rest of the form works.

What should you look at during the showing?

Look at the heat itself. Walk the house and note where the radiators or baseboard units are, and whether any rooms seem to have none. In a house with in-floor heat, ask which floors have it.

If you’re touring in the heating season, pay attention to how the rooms feel. Is one bedroom noticeably cooler than the rest? Is the upstairs much warmer than the main floor? Write it down. A cold room could have a simple explanation or a bigger one, and it’s exactly the kind of detail to pass along before the boiler gets looked at. If you’re touring in summer, ask the seller the same question instead, and ask whether any rooms use a space heater in winter.

Then find the boiler. Look at the area around it. Is there room to work on it? Are there stains, drips or rust on the floor or pipes nearby? Is there a data plate you can read? A photo of that plate saves you a phone call later. Notice, too, whether the boiler sits in a finished room or an open utility space, since that changes how easy it is to reach for service.

Check what’s in front of the radiators and baseboard units, too. You want them clear, and furniture shoved against them in every room is worth a question about which rooms the seller heated. Count the thermostats, ask whether the house has more than one heating zone and find out how the rooms you plan to use most are heated.

If the house is older, the historic home questions for Yankton buyers cover the other systems worth a close look.

Who should look at the boiler before you close?

A heating contractor who services boilers, during your inspection window. Your general home inspection still matters, but the boiler deserves someone who works on that equipment. Give the contractor a short list so the visit answers what you need:

  • How old is the boiler, and what condition is it in for its age?
  • Are there leaks, corrosion or signs of past repairs on the boiler or the piping?
  • Does every radiator, baseboard unit or floor zone heat?
  • What maintenance does it need now, and what would you budget for in the next few years?
  • What is its AFUE, and if it needed replacing, what would you recommend and roughly what would that cost?
  • Who in the area services this kind of boiler if it quits in January?

Boilers and furnaces are rated by annual fuel utilization efficiency, or AFUE. Asking for the current boiler’s AFUE and a replacement’s AFUE gives you a real comparison instead of a guess.

Ask for the answers in writing. If the visit turns up a problem, those notes are what you and your agent work from when you talk with the seller about a repair, a credit or the price.

What should you plan for after closing?

Plan the first winter before it arrives. Federal fire and air-quality guidance says to have heating equipment cleaned and inspected by a professional every year. If the seller can’t show a recent service visit, book one for your first fall in the house, and put it on the calendar for every fall after that.

Learn the system while the seller can still show you. At your final walk-through, ask the seller to point out the thermostats, the boiler’s on and off switch and anything they adjust when the weather turns. Write it down or take a short video. Save the service company’s name and number somewhere you’ll find it on a cold night.

Then think about the first cold snap. Turn the heat on early in the fall, before you need it, and walk the house while it warms up. Note any radiator or baseboard that stays cool and any noise that seems new, and mention them at the yearly service visit.

Carbon monoxide alarms go on the same list. Every home should have them, and a gas or oil boiler burns fuel. Confirm the house has working alarms before your first night there, and add them if it doesn’t.

Keep an eye on the bills, too. Compare your first winter’s heating bills with what the seller shared. A big jump is worth looking into, especially if you bought in summer and never saw the system run hard. Our home energy audit vs. utility bills guide walks through how to read those numbers.

If you’re comparing several homes with different heating systems, the Yankton buyer guide is a good place to line up the rest of your questions.

Frequently Asked Questions

Does the seller have to tell me how old the boiler is?

The South Dakota disclosure form asks for the home heating system type and its age, if known. If the seller doesn't know, the form allows that answer. Ask for service records and check the equipment's data plate during your inspection.

Who should look at a boiler before I close?

A heating contractor who services boilers, during your inspection window. Tell your general home inspector the house has boiler heat too, so the two reports cover the system together.

How is a boiler's efficiency rated?

By its annual fuel utilization efficiency, or AFUE. Ask the contractor for the AFUE of the existing boiler and of any replacement you might consider, and compare them side by side.

Should a boiler-heated home have carbon monoxide alarms?

You should have them. Federal guidance says every home should have carbon monoxide alarms, and a gas or oil boiler burns fuel.

Michelle Maloney

About the Author

Michelle Maloney is the Broker/Owner of Maloney Real Estate in Yankton, South Dakota. She helps buyers and sellers understand the local market, compare their options, and make confident real estate decisions across Yankton and southeast South Dakota.

Listings load as you scroll. Search all listings.

Questions About the Yankton Market?

Ask Michelle's team about pricing, neighborhoods, timing, or your next move. No pitch, no pressure.